Yonaka YMCB-PRE9701 Catback 2.5"

Similarly Modded Rides

Yonaka YMCB-PRE9701 Catback 2.5"

Photos:

Comments

Details

Rating:

Review:

Honda Prelude 1997-2001 Catback Exhaust (will fit all models, but will not fit SH model) *SH model has a shorter length header. You will need to cut and remove pipe from our resonator midpipe to fit. Bends are the same* This Yonaka Motorsports catback exhaust system is made of fully polished stainless steel, with 2.5" OD mandrel bended piping, and a 4.25" tip. Expect a quiet, clean, deep hum, without that irritating mid range raspy sound. Direct bolt-on fit to OEM. All installation hardware is included. Disclaimer: Recommended for off-road use only. Check with your local ministry of transportation in regards to exhaust regulations.


Details:

Status

Installed


Vendor

Yonaka Motorsports


xmlns="http://www.w3.org/2000/svg" xmlns:xlink="http://www.w3.org/1999/xlink">Asset 4Asset 3Check marlCreated using Figma