2003 Land Rover Defender
Broken crank sensor, fix this, then she will start
A novel way to put a gearbox back into my #landrover #defender
Sump is down to replace shaft seal and reseal sump gasket.
It's hammering down raining and I have no choice I must get this jeep back on the road, so rain or
Need to replace centermass flywheel. Very loose even with the 8 bolts on. Also if you look closer t
Taking out clutch assembly new center tool
Allways a good idea to take a photo of this before you take this apart (which I did). Otherwise I'd
Gearbox repaired, new release bearing, new transfer box seals #landrover #defender
Gearbox cleaned and prepped ready to be fixed
Gearbox looks good I hope it's just the 5th gear. I will want all the bearings changed just in case
What happened with this?
5th gear is whining, I'm inspecting the inside of the gearbox for wear.
Only 5th? Probably something up with that gear only
It's common on all r380 gearbox's and I have no intention of getting rid of it. Landy life...
Bell housing off, a lot of oil in so I need to get seals on the gearbox changed
I need to replace the clutch also
Post by Valentine Lynam...
Gearbox out, what a pig of a job. I've busted every finger doing this with a friend
I need break this up and send away the gearbox to be fixed. I will service the transfer box and the hand brake also.
This is my gearbox drain nut. As you can see I have a lot of gearbox on there. I'm changing out the
A novel way of filling your rear differential with oil on it's annual service. It was quiet low and
It can be such a pain, I just got a simple pump device that screws on to the quart bottle and you pump by hand. So much easier than some of the things I used to do.
I feel cheap, I did this nonsense with a funnel.
I did it with a large injecter I bought on eBay, I wore most of the oil on myself and the tarmac. The wife was delighted with it...
Haha! Excellent story!
Lol, I did that many times, after this pump thing , never again!
I don't mind it Robert it takes a while and if I get a spill I can catch it. I only paid 10 euro for this made up pump, it's better than 150
That's not bad, the thing I got was pretty cheap too. Anything beats trying to squeeze the fluid out of the bottle or using gravity via precariously placed funnels and hoses. Lol
Nice! It may be overkill for the job, but that makes it even better as far as I am concerned!
I over engineer everything dude!!
I like overdoing things, it's fun. I'm working on over engineering some Volvos at present!